Blizzard-lighting Motif Fresco (Rev A) Bedienungsanleitung PDF herunterladen (Seite 13)

Page 13

Setting the DMX Address

1.) To set the starting DMX address, push the

<S> button. You’ll see the LEDs ash 3 times in a

sequence of colors that indicate the currently set

DMX address. For example, if the DMX address is

currently 001, the ashes would be white (zero)/

white (zero)/ red(one). (See static color table)

2.) Enter a 3-digit DMX address: 001-512.

3.) Now you’ll see the LEDs ash 3 times per digit

you enter, and notably, they will ash the assigned

static color that corresponds to that digit. For

example, setting the xture to the DMX address of

010, the ashes would be white (zero)/ red (one)/

white (zero). (See static color table)

*You can use the remote control while in DMX mode to

switch to any other mode. Press the <D> button on the

remote to return to DMX mode.

Static Colors

To use xture in static color mode, press either the <R>, <G>, or <B> buttons,

and then one of the numeric buttons (0-9). The color table below shows the static

color for each number.

Static color table

Button 0 Button 1 Button 2 Button 3 Button 4

White Red Orange Light Yellow Green

Button 5 Button 6 Button 7 Button 8 Button 9

Cyan Blue Purple Pink Yellow

DMX Mode

The Motif Fresco™ will automatically recognizes a DMX signal when connected to a

controller, and will function in 3-channel RGB color mixing mode. If the DMX signal is

lost, the xture will revert to its previously set mode.

You can use the remote control while in DMX mode to switch to any other mode.

Then to return to DMX mode, press the <D> button.

Using The Remote Control

All the goodies and different modes possible with the Motif Fresco™ are also acces-

sible by using the IR remote control (sold separately).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

Blizzard-lighting Motif Fresco (Rev A) Bedienungsanleitung Seite 13